Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Haverhill Homeowners
When a garage door spring lets go, the door usually won’t lift, and sometimes it slams down hard enough to bend a panel or bow a track. A spring that’s already stretched or worn can fail with no warning at all. That noise you heard from the garage is the most common one we get called about: a loud snap, followed by a door that won’t budge. Our technicians have up to 12 years of experience with high-tension spring work, and spring repair is one of the jobs we do most often in Haverhill. Same-day service is available for spring failures, so call (833) 508-9650.
We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- Typical spring repair in Haverhill runs $180 – $340 for one spring. A matched pair is usually replaced together and costs about twice that.
- Torsion and extension springs are under extreme tension. This is not a do-it-yourself repair.
- Same-day service is available for broken springs, and the price is quoted and agreed before any work starts.
- We service spring systems on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor doors.
What Our Garage Door Spring Repair Service Includes
Every spring job starts with finding out which spring system your door uses, because torsion and extension setups fail in different ways and need different parts. Here’s what the work covers.
Torsion Spring Replacement
A torsion spring is the coiled spring mounted on a steel shaft above the door, and it does the heavy lifting by twisting as the door closes and unwinding as it opens. When it breaks, the door becomes almost impossible to lift by hand and can drop the moment the opener releases it. We measure the wire size, inside diameter, and length of the old spring so the replacement matches your door’s actual weight, then reset the cable tension and balance the door before we leave.

Extension Spring Replacement
Extension springs run along the horizontal tracks on each side and stretch as the door closes. Older homes around Haverhill often still have them, and they’re the type most likely to cause damage when they snap because they recoil with force. We replace them in matched pairs, check the pulleys and cables they connect to, and confirm the door opens smoothly through its whole travel.

Broken Spring Repair
Most broken spring calls come down to one question: did the spring break clean, or did it take a cable or a bracket with it? We inspect the full assembly before quoting anything, because a snapped spring can unload a cable and shift a drum out of position. Once we know the extent of the damage, you get a written price before we touch a tool.

Spring Adjustment
Sometimes the spring isn’t broken, just out of tune. If your door feels heavy, slams shut, or the opener strains to lift it, the spring tension is usually the cause. We adjust the winding to bring the door back into balance so it stays where you leave it, halfway open or all the way up.
Safety Cable Installation
Safety cables thread through the middle of extension springs so that if one breaks, the spring stays contained instead of flying across the garage. Many older doors in Haverhill were installed without them. If your extension springs don’t have cables, we add them as part of the spring work.
Spring Inspection
Not every spring failure announces itself. A spring can stretch, lose tension, or develop a gap in the coil long before it breaks. We inspect the coils, the anchor points, the cables, and the door balance together, so you know what’s worn and what still has life left in it. If everything checks out, we tell you that too.
Safety note: torsion springs and their cables are under extreme tension, and releasing that tension the wrong way can cause serious injury. This is one repair where we’d rather you call a trained technician than risk a hand or an eye.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
We work on the brand already in your garage. LiftMaster and Chamberlain systems are among the most common in Haverhill homes, and their openers put specific demands on a door’s balance, so getting the spring tension right matters for the opener’s motor as much as for the door. Genie and Craftsman setups, many of them older, have their own quirks around spring sizing and travel limits that we’ve learned to recognize quickly.
On the door side, Clopay, Amarr, Wayne Dalton, and Raynor each build panels and track assemblies differently, which affects how a spring replacement gets dialed in. Clopay and Amarr doors, for instance, vary in weight by model, so the spring has to match the door, not a generic chart. Whether your door is a LiftMaster or Chamberlain system, a Genie, a Clopay, an Amarr, or any other make, we can help.
Signs You Need Garage Door Spring Repair Right Now
- A loud bang from the garage. That snap is usually a torsion spring breaking, and the door won’t open afterward. Don’t keep pressing the opener button; it will only strain the motor.
- The door feels extremely heavy when you lift it by hand. A balanced door should lift with little effort. If it feels like dead weight, the spring has lost tension or failed.
- The door slams shut or won’t stay open halfway. That’s a balance problem, typically a worn or misadjusted spring. It’s a safety issue, especially for kids and pets.
- You can see a gap in the spring coil. A visible gap means the spring has broken or is about to. Stop using the door until it’s checked.
- The opener strains or the door jerks on the way up. The spring is often the culprit, not the opener. Diagnosing it correctly saves you from replacing an opener that still has plenty of life.
Our Garage Door Spring Repair Process – Step by Step
- 1
We ask what happened before we arrive. A few questions about the noise, the door’s position, and whether the opener still runs tell us a lot. It also helps us bring the right springs for your door type.
- 2
We inspect the whole assembly, not just the broken part. We check the spring, cables, drums, and brackets, and test the door’s balance. A broken spring often reveals a cable or pulley that’s also worn.
- 3
You get a written price before any work starts. The estimate is free, and the price is set per job. Nothing gets added later without your agreement.
- 4
We replace the spring and reset the tension. We measure the replacement to match your door’s weight, wind it to the correct turns, and confirm the door is balanced before we put the tools away.
- 5
We test the door through full cycles and show you the result. We run the door up and down, check the safety reverse, and make sure the opener isn’t straining. You’ll see it working before we leave.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Haverhill?
A typical spring repair in Haverhill runs $180 – $340 for one spring, depending on the spring type, door size, and what else needs attention. That range covers the work most homeowners call about, but the written estimate is what sets your final price.
Here’s how the common scenarios break down:
| Service | Typical Estimated Range |
|---|---|
| Spring repair (one spring) | $180 – $340 |
| Matched spring pair | About twice the single-spring range |
| Cable repair | $130 – $250 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| Garage door repair (general) | $150 – $600 |
What affects the price: the type of spring (torsion vs. extension), the door’s weight and size, whether one spring or a matched pair is needed, and whether cables or drums were damaged when the spring let go. A door that slammed and bent a panel will cost more than a clean spring swap. A matched pair is usually replaced together, so a pair costs about twice the single-spring range.
How to avoid overpaying: ask for the price in writing before work starts, and ask whether the spring is being matched to your door’s weight. A spring that’s sized wrong wears out fast and you’ll be back where you started.
What’s included in the free estimate: a full inspection of the spring system, cables, and door balance, plus a written price. The price is quoted and agreed before any work begins.
Garage Door Spring Repair Near Haverhill – Our Service Area
We provide Haverhill Garage Door Repair Co service across the Merrimack Valley, including Groveland, Methuen Town, Merrimac, West Newbury, Georgetown, Lawrence, North Andover, Amesbury Town, Andover, Boxford, and Newburyport. Spring failures are one of the most common calls we get from these towns, and same-day service is often available for them. If you’re in Groveland or Methuen Town, we also handle garage door spring repair and garage door spring repair close to home.
Serving Haverhill, MA – Our Local Coverage Area
We serve Haverhill and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Haverhill
Garage door spring repair is the replacement, adjustment, or inspection of the springs that counterbalance your door’s weight. Torsion springs mount above the door and twist; extension springs run along the side tracks and stretch. Either type carries extreme tension, which is why this repair calls for a trained technician rather than a handyman. We handle torsion and extension spring work routinely, including the matched pairs most doors need.
Most spring repairs take about an hour to two hours once the technician is on site, depending on the spring type and whether cables or other parts need attention. A simple torsion spring replacement is usually on the shorter end. A door that slammed and damaged a track or panel takes longer. We’ll tell you what to expect when we quote the job.
Typical spring repair in Haverhill runs $180 – $340 for one spring, and a matched pair is usually replaced together at about twice that range. The exact price depends on the spring type, door size, and whether cables or drums were damaged. The written estimate sets the final price, and the price is agreed before any work starts. Call (833) 508-9650 for an exact quote; estimates are free.
Yes. We service spring systems on Chamberlain, Genie, Clopay, Amarr, and the other major brands found in Haverhill garages. Each brand has its own door weight and track design, and the spring has to match. We check the brand and model before quoting so the replacement spring is sized right the first time. If you’re unsure what brand you have, we can identify it during the inspection.
Same-day service is available for spring failures in Haverhill, subject to scheduling. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. We’re closed on Saturday. Call (833) 508-9650 to check availability.
We stand behind the work, and any warranty terms are explained in the written estimate before the job begins. Ask your technician to walk you through what’s covered so there are no surprises. The estimate is free, and the price is quoted and agreed before any work starts. Call (833) 508-9650 to schedule.
Clear the garage floor around the door and make sure the technician can reach the spring assembly, which is usually above the door or along the side tracks. Don’t try to lift or operate the door once a spring has failed. If you have the door’s brand or model number, have it handy, but it’s not required. We’ll inspect the full assembly when we arrive.
Schedule Your Garage Door Spring Repair Service in Haverhill Today
A broken spring leaves your door stuck and your garage exposed. We handle spring repair on the major brands, from Chamberlain and Genie openers to Clopay and Amarr doors, and we’ll give you a written price before any work starts. Our technicians have up to 12 years of experience with high-tension spring work. Call (833) 508-9650 for a free, no-obligation estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Related services: garage door repair, garage door opener repair, garage door installation, and emergency garage door service.
Written by the team at Haverhill Garage Door Repair Co.